ISO 14313:2007

INTERNATIONAL ISO
STANDARD 14313
Second edition
2007-12-15

Petroleum and natural gas industries —
Pipeline transportation systems —
Pipeline valves
Industries du pétrole et du gaz naturel — Systèmes de transport par
conduites — Robinets de conduites




Reference number
ISO 14313:2007(E)
©
ISO 2007

---------------------- Page: 1 ----------------------
ISO 14313:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2007 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 14313:2007(E)
Contents Page
Foreword. v
Introduction . vi
1 Scope .1
2 Conformance.1
2.1 Units of measurement .1
2.2 Rounding .1
2.3 Compliance to standard.1
3 Normative references .2
4 Terms and definitions .4
5 Symbols and abbreviated terms .7
5.1 Symbols .7
5.2 Abbreviated terms .7
6 Valve types and configurations.8
6.1 Valve types .8
6.2 Valve configurations .9
7 Design .23
7.1 Design standards and calculations .23
7.2 Pressure and temperature rating .24
7.3 Sizes.24
7.4 Face-to-face and end-to-end dimensions .
...