Measurement of radioactivity in the environment — Air: radon 222 — Part 13: Determination of the diffusion coefficient in waterproof materials: membrane two-side activity concentration test method

ISO/TS 11665-13:2017 specifies the different methods intended for assessing the radon diffusion coefficient in waterproofing materials such as bitumen or polymeric membranes, coatings or paints, as well as assumptions and boundary conditions that shall be met during the test. ISO/TS 11665-13:2017 is not applicable for porous materials, where radon diffusion depends on porosity and moisture content.

Mesurage de la radioactivité dans l'environnement — Air : radon 222 — Partie 13: Détermination du coefficient de diffusion des matériaux imperméables : méthode de mesurage de l'activité volumique des deux côtés de la membrane

General Information

Status
Published
Publication Date
12-Oct-2017
Current Stage
9020 - International Standard under periodical review
Start Date
15-Jan-2024
Completion Date
15-Jan-2024
Ref Project

Buy Standard

Technical specification
ISO/TS 11665-13:2017 - Measurement of radioactivity in the environment -- Air: radon 222
English language
37 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

TECHNICAL ISO/TS
SPECIFICATION 11665-13
First edition
2017-10
Measurement of radioactivity in the
environment — Air: radon 222 —
Part 13:
Determination of the diffusion
coefficient in waterproof materials:
membrane two-side activity
concentration test method
Mesurage de la radioactivité dans l'environnement — Air : radon
222 —
Partie 13: Détermination du coefficient de diffusion des matériaux
imperméables : méthode de mesurage de l'activité volumique des
deux côtés de la membrane
Reference number
ISO/TS 11665-13:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO/TS 11665-13:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/TS 11665-13:2017(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms, definitions and symbols . 1
3.1 Terms and definitions . 1
3.2 Symbols . 5
4 Principle of the test method . 6
5 Measuring system . 6
5.1 Components of the measuring system . 6
5.2 Configuration of the measuring system . 7
6 Test methods . 9
6.1 General information . 9
6.2 Method A — Determining the radon diffusion coefficient during the phase of non-
stationary radon diffusion . 9
6.3 Method B — Determining the radon diffusion coefficient during the phase of
stationary radon diffusion .10
6.4 Method C — Determining the radon diffusion coefficient during the phase of
stationary radon diffusion established during ventilation of the receiver container .11
7 General application procedures .12
7.1 P
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.